DX NetOps

Expand all | Collapse all

spectrumgtw UIM/Spectrum alarms oneway setup

Jump to Best Answer
  • 1.  spectrumgtw UIM/Spectrum alarms oneway setup

    Posted 11-14-2019 04:42 AM
    To be able to configure unidirectional (UIM -> Spectrum) before activating the UIM probe, I need to set it manually in the prob config. It seems like its the <Directional_Alarm_Sync> tag which handle this. However, its settings is just one digit - so I don't know whats what and I can't find it in the documentation.

    Can anyone confirm that the below is correct for <Directional_Alarm_Sync>:
    0 = bidirectional UIM <-> Spectrum
    1 = unidirectional UIM <- Spectrum
    2 = unidirectional UIM -> Spectrum


  • 2.  RE: spectrumgtw UIM/Spectrum alarms oneway setup

    Posted 11-14-2019 08:38 AM
    Hi Robert,

    Yes, correct.
    But why don't you configure the spectrumgtw probe via Admin Console?



    ------------------------------
    Technical Support Engineer IV
    Broadcom Inc
    ------------------------------



  • 3.  RE: spectrumgtw UIM/Spectrum alarms oneway setup

    Posted 11-14-2019 08:46 AM
    You have to activate the probe to be able to configure using Admin Console and to be sure it doesn't spam UIM with alert from Spectrum, I want to be sure its in unidirectional mode before I activate it.

    /Rob


  • 4.  RE: spectrumgtw UIM/Spectrum alarms oneway setup
    Best Answer

    Posted 11-14-2019 09:05 AM
    Just ensure the UIM integration is not enabled in OneClick Administration prior configuring the spectrumgtw probe.


    ------------------------------
    Technical Support Engineer IV
    Broadcom Inc
    ------------------------------