Hi Rahul,
Open "MIB Tools", find the MIB file on the left-side panel, go to the "Map" tab on the right-side panel. At the bottom of the right-side panel, you should see the traps in that MIB file. If they are listed, but do not have an "Event Code" associated with them, then you first need to do that (using the acorn + icon).
After you do that, then you should go to "Event configuration" and change the event severity according to your needs.
Best regards,
Zacchi
------------------------------
Marcelo Zacchi
CA Spectrum consultant
Nets Denmark
------------------------------
Original Message:
Sent: 06-14-2019 12:41 PM
From: Rahul Rawat
Subject: How to convert imported MIB OIDs into alarm
Hello All,
I am on spectrum 10.3.2 version.
Successfully imported and compiled Symantec_Appliances MIBs, So now i wants to process them to alarms, how can i do this? What is the procedure?
Rahul Rawat