You need to use an ID and password provisioned by eEM. For WCC0004 application.
Try your own ID first then setup an application ID and provision it accordingly.
I suggest getting your AutoSys /WCC admin to assist, Otherwise, if you are that person, may I suggest going through the manuals and wiki
So that you do not make a mistake.
Hope that helps and good luck.
Steve C.
Nothing in this message is intended to constitute an electronic signature unless a specific statement to the contrary is included in this message.
Confidentiality Note: This message is intended only for the person or entity to which it is addressed. It may contain confidential and/or privileged material. Any review, transmission, dissemination or other use, or taking of any action in reliance upon this message by persons or entities other than the intended recipient is prohibited and may be unlawful. If you received this message in error, please contact the sender and delete it from your computer.