Cluster port documentation mismatch

[Nikola Milosavljevic]

Hello everyone,

I would like to report the following issue:

Port 7902 has been added recently to this page for version 3.3.1: IP Addresses and Ports for Network Connectivity

While on this page: Cluster Deployment Requirements  The same port is not shown in the cluster requirements.

I know for sure that this port wasn't in the requirements before for this version even last year nor for the previous versions as i was writing Architecture for PAM deployments for them. Why is this port added now and wasn't a requirement before, even for versions that never had this port before today?

Best regards,

------------------------------
Nikola Milosavljevic
Security Consultant
------------------------------

[Joseph Fry]

I don't seen 7901 or 7902 in use or listening on my cluster members.  That is not to say that they aren't required, but our particular cluster works fine without them.

That said, members of a site should ideally not be separated by a firewall.  They should be on the same VLAN to ensure that you have minimal latency and fewer potential points of failure.