so before snmpcollector was configured to monitor the device all the interfaces showed up.
after only two show up.
Was the device being monitored via another probe before snmpcollector?
What does the snmpcollector configure GUI show for interfaces for this device?
------------------------------
Support Engineer
Broadcom
------------------------------
Original Message:
Sent: 01-13-2021 10:56 AM
From: neal timm
Subject: Snmpcollector not showing all interfaces on a device
All the interfaces show up fine in USM but after discovery in snmpcollector probe only 2 interfaces show up out of about 20. It's a Cisco ASA device so it's supported.