Not understanding this, please detail it out, and versions will help.
As Franklin said UMP > Design > Performance Reports Designer > select by QoS > select any of the qos_azure to see what targets show up > drag and drop a target onto the graph for current data.
Other way is USM > Device > Metrics tab.
What are the steps to the performance report you mention?
------------------------------
Support Engineer
Broadcom
------------------------------
Original Message:
Sent: 07-28-2020 06:50 AM
From: Pratiman Chaddha
Subject: Azure QOS Data not reflecting under performance report
Hi Frank,
I analysed it more and found out that in azure probe the data which is getting collected is for Count type of data for QOS_AZURE_EXPRESS_ROUTE_CIRCUIT_BITS_IN_PER_SEC . But data which is coming in azure is for average type of aggregation that's why it is coming as null.
Any solution to fix it ?
Regards
Pratiman
Original Message:
Sent: 07-27-2020 01:36 AM
From: Franklin D'souza
Subject: Azure QOS Data not reflecting under performance report
Hi ,
Is the data not seen in UMP performance reports or USM or both
Do RN_xxx tables in database for Azure QOS show any data
If data is seen in Dr Nimbus but not in database can check in data_engine logs if any errors seen for inserting the azure data
Original Message:
Sent: 07-25-2020 07:20 AM
From: Pratiman Chaddha
Subject: Azure QOS Data not reflecting under performance report
Hi All,
I'm not getting Azure probe QOS data on UMP. However I can see data getting collected via, Dr Nimbus and also QOS entry are present in CA_UIM DB.