DX Unified Infrastructure Management

 View Only
  • 1.  SNMPCollector - Interface Monitoring

    Posted Jan 22, 2019 09:04 AM

    Hello CA Guys,


    I would like to know how to configure interface monitoring in SNMPC?
    For example, in interface_traffic we would do a discovery of the interfaces and select only the ones we would like to monitor.

    Is it possible to do this in the SNMPCollector probe?

    I saw that the probe works with a regex filter, but when the client does not have a default name for each interface?
    Is it necessary to create a filter for each equipment instead of a general filter?


    Thank you for your help

  • 2.  Re: SNMPCollector - Interface Monitoring

    Posted Jan 23, 2019 10:01 AM

    Filters are needed or not needed based on the need.

    If all interfaces are to be monitored the same then a filter is not needed.

    snmpcollector Configure Monitoring with Templates - CA Unified Infrastructure Management Probes - CA Technologies Docume… 

  • 3.  Re: SNMPCollector - Interface Monitoring
    Best Answer

    Broadcom Employee

  • 4.  Re: SNMPCollector - Interface Monitoring

    Broadcom Employee
    Posted Jan 23, 2019 10:50 PM
      |   view attached

    One note - If there is no filter present, everything is considered as target managed by template.

    For example, an built-in template "Default Template" has built-In the Interface Rules (ifOprStatus=1 AND ifAdminStatus=1)

    In this rule, interface that does not satisfy these criteria are excluded from template management scope.