Moving a Monitoring Configuration from one domain to another.

[rod.cook]

We have two environments that are to duplicate each other, DEV and PROD.  Has any one have a methodology to move a monitoring configuration from one domain to another?  I have used the methodology of moving a configuration from one group to another, but always within a domain.  

[David Kim]

The following KB article may helps.

 

How to move hubs/robots to a new CA UIM (Nimsoft) domain

https://www.ca.com/us/services-support/ca-support/ca-support-online/knowledge-base-articles.tec000002702.html

[rod.cook]

Thanks for the reply.  This question is specific to Monitoring configurations that are assigned to groups in USM.  I have no problem in moving hubs and/or robots to a new domain.  thanks again

[Yu Ishitani]

Hello

Please confirm if MCS config is what you're talking about when you mention "Monitoring configurations that are assigned to groups" ?

 

Regards,

Yu Ishitani

[rod.cook]

yes

[Felipe Ribeiro Soares]

Good afternoon, David.

 

In the tecdoc TEC000002702 that you posted says that to change a HUB to another domain it is necessary to change the hub.cfg, but does not say which parameters need to be changed.

 

Can you tell what these parameters are?

 

I need this procedure to change the hubs I have for a new domain, and consequently the robots that are below those hubs.

Thank you.

[Silvio Okamoto]

This is the updated link:

Article title: How to move hubs/robots to a new CA UIM (Nimsoft) domain

https://ca-broadcom.wolkenservicedesk.com/external/article?articleId=34311

------------------------------
Technical Support Engineer IV
Broadcom Inc
------------------------------