DX Unified Infrastructure Management

  • Private Community
 View Only

  • 1.  MTP analysis has No Data but TIM on MTP has data packets processed. How? what is wrong with MTP.

    Posted Sep 23, 2016 09:27 AM

    I have MTP 9.2, and TIM9.1.2 install on it, its CA6000 series hardware. I am able to see TIM working fine and data and transactions caputured. but the MTP analysis page is showing No Data, when i go from defects to analysis network it shows me no data.

     

    I have same setup for other environment and thr is works fine.

     

    Any help is greatly appreciated.



  • 2.  Re: MTP analysis has No Data bust TIM on MTP has data packets processed. How? what is wrong with MTP.

    Broadcom Employee
    Posted Sep 23, 2016 10:00 AM

    Dear Pradeep:

    I wonder this is more of a  question on the MTP side. Check your MTP Status page on process health . If the analysis page is showing no data, then check if you are seeing two way traffic or the traffic is filtered out

     

    Thanks

    Hal German



  • 3.  Re: MTP analysis has No Data bust TIM on MTP has data packets processed. How? what is wrong with MTP.
    Best Answer

    Broadcom Employee
    Posted Sep 23, 2016 10:42 AM

    Hi Pradeep,
    I found a similar question in the CA Infrastructure Management community site:
    https://communities.ca.com/message/241731191?commentID=241731191#comment-241731191 

    I suggest you to post this question there too.
    I hope this helps,
    Sergio



  • 4.  Re: MTP analysis has No Data bust TIM on MTP has data packets processed. How? what is wrong with MTP.

    Broadcom Employee
    Posted Sep 23, 2016 12:00 PM

    Moving to IM forum...