DX Unified Infrastructure Management

 View Only
  • 1.  Maintenance mode not working on a two hub environment

    Posted Sep 03, 2015 09:50 AM

    Hello,

    this is my environment:

     

    -HubA: where ump installed and nas

    -HubB: ha probe and nas

     

    If I set thorugh the ump web portal the maintenance to a robot connected to hub B, the alarm are not suppressed.

    What's wrong? is something missin?

    thank you



  • 2.  Re: Maintenance mode not working on a two hub environment

    Posted Sep 03, 2015 09:55 AM

    Not overly familiar with the inner workings of maintenance_mode, but it'll likely help if you explain in further detail what kind of nas setup you have, concerning replication.

     

    -jon



  • 3.  Re: Maintenance mode not working on a two hub environment
    Best Answer

    Posted Sep 03, 2015 07:21 PM

    In a multi-tier\multi-NAS environment, you can add a key in the NAS raw configure under the setup section to point to the main hub server nas:

     

    maintenance_mode_address=/<Domain>/<hub>/<robot>/maintenance_mode

     

    This should be done on any lower level hub nas probes.



  • 4.  Re: Maintenance mode not working on a two hub environment

    Posted Sep 04, 2015 01:41 AM

    Yes you are right, support confirm this, but first I need to upgrade to 8.2. I am on UIM 8.0