A client has expressed interest in using the new REORG utility function
which was provided on the SP4 tape. I currently have SP2 intalled so
the
next obvious question that I've been asked is what kind of effort is
required to install the SP4 maint tape? For those of you who have done
it,
is it essentially just a case of getting the tape and doing the SMP/E
RECEIVE and APPLY or are there other processes involved?
Dave Embury,
IBM Global Services
01/UCY/410/WLOO
410 Albert St., Waterloo. ON N2L 3V3
Internal IBM email: Dave Embury/Ontario/IBM@IBMCA
External (Internet) email:
emburyd@ca.ibm.com
Voice: (519) 880-2946 {5-2946}
Fax: (519) 746-4803
A picture is worth a thousand words but it uses up three
thousand times as much space on your hard drive.
This transmission may contain information that is privileged,
confidential
and/or exempt from disclosure under applicable law. If you are not the
intended recipient, you are hereby notified that any disclosure,
copying,
distribution, or use of the information contained herein (including any
reliance thereon) is STRICTLY PROHIBITED. If you received this
transmission
in error, please immediately contact the sender and destroy the material
in
its entirety, whether in electronic or hard copy format.
"
IDMS Public Discussion Forum
IDMS-L@LISTSERV.IUASSN.COM
SMTP
IDMS-L@LISTSERV.IUASSN.COM
IDMS-L@LISTSERV.IUASSN.COM
SMTP
Normal
Normal
Re: Installing the R16 SP4 maint tape
"Seems to me if all you want is that batch utility (I think it is called
reorg or reload express????...something like that) all you have to do is
lay down your new Sp4 loadlib with SMP/E and then check for additional
apars for this product from CA being this utility is new.