Installed nimsoft on one robot and getting communication error.
Ports are opened in bidirectional from Tool to robot and robot to tool.
UIM Version : 8.5.1
Receiving below error in controller log.
what do you mean by 'tool'?
controller communicates up to the hub, so robot controller communication errors are between the hub & robot.
best test is remote into robot system telnet <hub ip address>:48002
10054 is a winsock error
Windows Sockets Error Codes - Windows applications | Microsoft Docs
Connection reset by peer.An existing connection was forcibly closed by the remote host.
also best to use the latest robot & hub and
hub and tunnel connection settings in 7.x and 8.x - CA Knowledge
Avoiding communication errors when configuring UIM - CA Knowledge