Automic Workload Automation

  • 1.  How does Maximum RunTime (MRT) work

    Posted Apr 03, 2017 10:36 AM

    When testing MRT and the difference between the actual Object Runtime (eg: 50 seconds) and the MRT value (eg: 30 seconds) is less than a minute, you may get an inconsistent result (runs that go over the MRT may or may not get cancelled due to going over the MRT value).

    This is because by default the internal timer within the Automation Engine is 20 seconds - so an MRT check is done every 20 seconds. So depending if the timer was right after an MRT, it could fire immediately or let it go. It just depends on this every 20 seconds...

    Note: The MRT behavior information is from our Dev




  • 2.  How does Maximum RunTime (MRT) work



  • 3.  How does Maximum RunTime (MRT) work

    Posted Apr 03, 2017 03:50 PM
    Ah thanks Wolfgang. I had this issue prior to Josef's post. I should double-check next time before creating a new discussion :smile:



  • 4.  How does Maximum RunTime (MRT) work

    Posted Apr 04, 2017 09:13 AM
    NP - meanwhile community is quite big so its easier to overlook a topic...:-)