DX Infrastructure Manager

Expand all | Collapse all

Probes on a Cluster

  • 1.  Probes on a Cluster

    Posted 03-09-2010 11:31 PM
    Probes that are configured on a Cluster are sending alarms that have the cluster ip address as the "hostname and source". Is there a way to have alarms from the active node only, or at least label the alarm in a way that it is more identifiable as opposed to the cluste ip?


  • 2.  Probes on a Cluster

    Posted 03-10-2010 06:24 PM
    The contents of the source field in an alarm are usually controlled by the probe.  Some probes allow you to change this behavior.  I am pretty sure that most probes do not exhibit this behavior on clusters, although some certainly do.  Perhaps it would help if you could be more specific about what alarms/probes you are having problems with?

    I know the cdm probe does this for cluster disk alarms, but it has a
    configuration setting to tell it whether to use the cluster name or
    IP.

    -Keith


  • 3.  Probes on a Cluster

    Posted 03-10-2010 11:09 PM
    I am getting this with the CDM disk errors, as well as all Exchange probe errors. I will take a look at CDM again to see if I find the setting you speak of.


  • 4.  Probes on a Cluster

    Posted 03-10-2010 11:28 PM
    Found the CDM cluster setting. Thanks