IT Process Automation

Expand all | Collapse all

Passing Variables into a custom operator

Jump to Best Answer
  • 1.  Passing Variables into a custom operator

    Posted 05-09-2013 11:50 AM
    Good morning,

    I had previously created a thread for this when working in PAM 4.1 and found the answer I was looking for: 100045545

    However, I'm trying to do the same process in 4.1 and seem to be running into issues. Did they change the way we pass variables into a process again?

    Thank you,

    Clinton


  • 2.  Moving thread.

    Posted 05-10-2013 02:55 PM
    Moving this thread to General Discussion where questions are asked and answered.

    Mary


  • 3.  RE: Passing Variables into a custom operator
    Best Answer

    Posted 05-13-2013 02:15 PM
    We have a resolution from CA Support on this:

    Upon further investigation I found that the setting called "Expand Macro in
    the value" when set to true exhibits this behavior of adding the "Operator"
    level. You can set that to false by editing the custom operator, browsing
    to Page Layout>RunProcess>Local and on the far right, change the setting to
    false.