The Water Cooler

  • 1.  SAN Switch 300 power supply failed

    Posted Mar 19, 2014 06:11 PM

    I have a customer with a dead SAN Switch 300.  We suspect a failed power supply.  I have a new, replacement switch but rather than swap out a virgin, unconfigured switch I am wondering what others think about swapping the power supply from the new unit to the old unit.  Or, possibly swapping the memory card from the failed unit into the new unit.

     

    The goal here is to preserve the customer's configuration and avoid reconfiguration.

     

    Any thoughts?

     

    There is another 300 switch on this SAN, would that config automatically populate to a new switch when added into the fabric?

     

    It's been a while since I have had to work with a FC network.

     

    Thanks in advance for any replies,

     

    Dave


    #TheWaterCooler


  • 2.  Re: SAN Switch 300 power supply failed

    Posted Mar 19, 2014 11:12 PM

    To avoid confusion, Info & Feedback forum is intended for Posting Info and Feedback about the Brocade Community, and not for problem or question specific related to Brocade Product.

     

    the same

     

    http://community.brocade.com/t5/Fibre-Channel-SAN/SAN-Switch-300-power-supply-failed-any-ideas/m-p/57844#M19422

     

     


    #TheWaterCooler