Brocade SAN Health Community

Expand all | Collapse all

I'm trying to run SAN Health on 4 6547 switches that are part of an IBM flex system.

  • 1.  I'm trying to run SAN Health on 4 6547 switches that are part of an IBM flex system.

    Posted 08-28-2014 10:08 AM

    I can run the connectivity check just fine. Just fyi these switches are in Access Gateway mode. 

    I can't get SAN Health to accept any name for the Fabric. So I can't pass the pre-flight check


    #BrocadeSANHealthCommunity


  • 2.  Re: I'm trying to run SAN Health on 4 6547 switches that are part of an IBM flex system.

    Posted 08-28-2014 01:40 PM

    Hi Bruce,

    Please make sure you are using the latest SAN Health, 4.0.3, available at http://brocade.com/sanhealth.

    Any time SAN Health rejects a fabric name it will give the reason in the onscreen log. Look there for the reason. If you still have problems, send the log and relevant screenshots to shadmin@brocade.com and we will look into the issue.

     

    Regards,

    HealthAdmin


    #BrocadeSANHealthCommunity