Brocade Management Software Community

fabos not yet initialized

  • 1.  fabos not yet initialized

    Posted 12-27-2013 06:13 AM

    Checking system RAM - press any key to stop test

    Checking memory address: 00100000

    System RAM test using Default POST RAM Test succeeded.

    set_bootstatus: BS_LOAD_OS, platform_idx = 1

    Type run flash_nfs to mount root filesystem over NFS

    Hit ESC to stop autoboot:  0
    Map file at LBA sector 0x183e10
    ## Booting image at 00400000 ...
       Image Name:   Linux-2.6.14.2
       Image Type:   PowerPC Linux Multi-File Image (uncompressed)
       Data Size:    4269595 Bytes =  4.1 MB
       Load Address: 00000000
       Entry Point:  00000000
       Contents:
       Image 0:  3190917 Bytes =  3 MB
       Image 1:  1078663 Bytes =  1 MB
    ## Current stack ends at 0x1FAEEBE8 => set upper limit to 0x00C00000
    ## initrd at 0x0070B0D4 ... 0x0081265A (len=1078663=0x107587)
       Loading Ramdisk to 1f9e6000, end 1faed587 ... OK
     initrd_start = 1f9e6000, initrd_end = 1faed587
    ## Transferring control to Linux (at address 00000000) ...
    Installing Linux 2.6 Kernel
    Attempting to find a root file system on hda2...
    INIT: version 2.78 booting
    Bypassing firmware validation.
    --- Partition /dev/hda1 is inconsistent.
    --- Its content will be restored to be the same as that of /dev/hda2.
    --- Please check the version and re-load firmware if necessary after the system boots up.
    INIT: Entering runlevel: 3
    Starting Fabric OS Services...
    FIPS off, RRD...
    **************************************************************
    *                                                            *
    * System booted     5 times within    3000 seconds!          *
    *                                                            *
    * Fabric OS has detected frequent switch reboot condition.   *
    * Following actions can be taken to recover the switch:      *
    * - remove or replace any problem blades (if applicable to   *
    *   platform).                                               *
    * - use supportsave to collect supportsave data.             *
    *                                                            *
    **************************************************************

    login:

    sysmodAttach open failed: No such device or address
    fabsys device open: No such device or address
    Raslog Module Initialisation failed rc=-1
    fabsys device open: No such device or address


    #BrocadeManagementSoftwareCommunity