Brocade Fibre Channel Networking Community

Expand all | Collapse all

Configure options (set local switch parameters) for FOS 7.2

  • 1.  Configure options (set local switch parameters) for FOS 7.2

    Posted 04-23-2014 12:26 PM

    Is there documentation anywhere that describes each option for the configure tool  (ie switchdisable,configure (set local switch parameters) to change settings?  I noticed there are some differences when I do a configshow on a switch running 7.0 and a switch running 7.2.

    Thanks in advance

     


    #BrocadeFibreChannelNetworkingCommunity


  • 2.  Re: Configure options (set local switch parameters) for FOS 7.2

    Posted 04-24-2014 08:24 AM

    hmm configshow shows a lot of output.

     

    Some need to be identicall on all switches like

    fabric.ops.E_D_TOV
    fabric.ops.R_A_TOV

    Some are ment to be different like the DID.

     

    Can you post an overview of the differences you are concerned about?


    #BrocadeFibreChannelNetworkingCommunity


  • 3.  Re: Configure options (set local switch parameters) for FOS 7.2

    Posted 04-25-2014 07:16 AM

    My vendor is telling me I should be able to set the following settings:

      ssl attributes (yes, y, no, n): [no] yes
    Certificate File. (filename or none): [10.33.13.182.crt] 192.1.2.3.crt
            CA Certificate File. (filename or none): [none]
            Select length of crypto key.
    (Valid values are 40, 56, and 128.): (40..128) [128]
    http attributes (yes, y, no, n): [no] yes
    HTTP Enabled (yes, y, no, n): [yes] no
    Secure HTTP Enabled (yes, y, no, n): [no] yes

     

    However I do not see the http attribute fields in 7.2.

     

    Thanks,

     


    #BrocadeFibreChannelNetworkingCommunity


  • 4.  Re: Configure options (set local switch parameters) for FOS 7.2

    Posted 04-26-2014 12:02 AM

    Hi, if the switch is in FIPS mode there's only https.

     

    You can also block port 80 by setting up an ipfilter.


    #BrocadeFibreChannelNetworkingCommunity


  • 5.  Re: Configure options (set local switch parameters) for FOS 7.2

    Posted 04-24-2014 10:41 AM

    Hi storagejsg, 

     

    some of them are documented in the FOS Command Reference guide under configure: 

     

    http://www.brocade.com/downloads/documents/product_manuals/B_SAN/FOS_CmdRef_v720.pdf


    #BrocadeFibreChannelNetworkingCommunity