Brocade Fibre Channel Networking Community

Expand all | Collapse all

Is it possible to have https working with an access gateway%3F

  • 1.  Is it possible to have https working with an access gateway%3F

    Posted 03-27-2014 02:49 AM

    I'm using BNA in https discovery mode. Is it posible to install a certificate to an AG and discover it with BNA?

     

    Best Regards, MiikaP


    #BrocadeFibreChannelNetworkingCommunity


  • 2.  Re: Is it possible to have https working with an access gateway%3F

    Posted 03-27-2014 03:30 AM

    Hi,

     

    if the switch model supports HTTPS, I reckon that if doesn't matter if it is working in AG mode or not.

     

    Rgds


    #certificate
    #BrocadeFibreChannelNetworkingCommunity
    #https


  • 3.  Re: Is it possible to have https working with an access gateway%3F

    Posted 03-27-2014 06:24 AM

    Hmm... It says:

     

    encprd08-agw1:admin> seccertutil
    Error: This command is not supported in AG mode

    when I try to run seccertutil...

     

    Rgds, MiikaP


    #BrocadeFibreChannelNetworkingCommunity


  • 4.  Re: Is it possible to have https working with an access gateway%3F

    Posted 03-28-2014 02:27 AM

    Hi,

     

    As per the CLI guide, when it comes to seccertutil, it states the following:

     

    This command is also supported in Access Gateway mode, for FCAP authentication between AG and  the switch.

     

    So it seems that this command is not supported in interactive mode (without parameters) and that it can only be used for FCAP auth against the switch.

     

    Rgds,

    Felipon


    #BrocadeFibreChannelNetworkingCommunity
    #accessgateway


  • 5.  Re: Is it possible to have https working with an access gateway%3F

    Posted 06-12-2014 01:03 AM

    Hi!

     

    After upgrade to v7.1.1c seccerttutil seems to work normally (at least genkey worked). Let's see whther HTTPS works after uploading the certificate..

     

    Rgds, MiikaP


    #BrocadeFibreChannelNetworkingCommunity