Brocade Fibre Channel Networking Community

Expand all | Collapse all

I am still receiving the "Interface disabled" block message

  • 1.  I am still receiving the "Interface disabled" block message

    Posted 08-19-2016 09:38 AM

    I have checked the ip filter settings and verified that port 80 is not blocked, but I am still not able to access the our DCX 8510s via the web console. Any suggestions?


    #BrocadeFibreChannelNetworkingCommunity


  • 2.  Re: I am still receiving the "Interface disabled" block message

    Posted 08-19-2016 10:41 AM

    @xSLx

     

    from command line

     

    check with command "ifmodeshow" is probable the interface is disable.

     

     


    #BrocadeFibreChannelNetworkingCommunity


  • 3.  Re: I am still receiving the "Interface disabled" block message

    Posted 08-19-2016 12:16 PM

    The command shows that the link is "ok". Any other suggestions? I've tried quite a few to no avail.


    #BrocadeFibreChannelNetworkingCommunity


  • 4.  Re: I am still receiving the "Interface disabled" block message

    Posted 08-19-2016 12:44 PM

    what say "hashow" command ?

     

     


    #BrocadeFibreChannelNetworkingCommunity


  • 5.  Re: I am still receiving the "Interface disabled" block message

    Posted 08-19-2016 12:47 PM

    Local CP (Slot 6, CP0): Active, Warm Recovered
    Remote CP (Slot 7, CP1): Non-Redundant


    #BrocadeFibreChannelNetworkingCommunity


  • 6.  Re: I am still receiving the "Interface disabled" block message

    Posted 08-19-2016 12:58 PM

     

    you have to executed "haenable" in order to enable HA and the Standby CP can get in Sync with the Active CP.

     

     


    #BrocadeFibreChannelNetworkingCommunity


  • 7.  Re: I am still receiving the "Interface disabled" block message

    Posted 08-19-2016 01:21 PM

    Sounds good. Is this a nondisruptive action? Also, this sounds like it is a necessary configuration change to make the CPs HA, but how does this relate to the web interface issue?


    #BrocadeFibreChannelNetworkingCommunity


  • 8.  Re: I am still receiving the "Interface disabled" block message

    Posted 08-19-2016 01:34 PM

    haenable is non-distruptive,

     

    ->but how does this relate to the web interface issue?

     

    I assume for some reason the service hang, and for this reason you cannot reached the Switch trough the web-tools.

     

    Q.:

     

    did you perhaps change Ip Address on this DCX ? and are all ip correct

     

    can be verified with "ipaddrshow"

     

    can you ping the standby CP ?

     

     


    #BrocadeFibreChannelNetworkingCommunity


  • 9.  Re: I am still receiving the "Interface disabled" block message

    Posted 08-19-2016 02:04 PM
    Another solution is your Web server might have died. In the caddy once hashow reports healthy you can do hareboot, which is non disruptive and that should fix the problem.
    #BrocadeFibreChannelNetworkingCommunity


  • 10.  Re: I am still receiving the "Interface disabled" block message

    Posted 08-29-2016 09:08 AM
    It's good now, thanks for the assistance everyone.
    #BrocadeFibreChannelNetworkingCommunity