Hello, purchased 6505 new, went through ezswitch setup, when I goto the IP and login as admin it starts EZswitch setup again, and in the section where you set Admin password will not accept anyting error is "failed to change password"
I am stuck unable to config switch via gui, I can also login to the CLI as Admin, but no idea how to config from there.
Any suggestion to get past the ezsetup wizrd to the GUI?
May be it will be useful - how to config it from CLI, "Brocade 6505 Hardware Installation Guide" guide, starting page 43, https://docs.broadcom.com/docs/12380322
i never used EZ setup, but if you like we may help you to configure switch via CLI.