I´m using integrated routing (FCR) in my core backbone, and I´m very close to maximum LSAN zone count, which is set to maximum hard limit 5000 LSAN zones.
My question is, in which way the FCR count LSAN zones.
1 LSAN zone with single initiator single target counts for 1 LSAN zoneFabric ID: 14 Zone Name: lsan_UBS_appvault002_nj20a_vnx_nj09_02_spa0_ix09a_zone50:01:43:80:28:d1:3e:68 initiator50:06:01:60:08:60:1d:0e target
1 LSAN zone with single initiator multiple targets count for 1 LSAN zone or multiple LSAN zones?Fabric ID: 14 Zone Name: lsan_UBS_exmrdk002_nj20a_vmax3_nj_02_6e1_6g1_12e1_12g1_zone10:00:00:05:1e:fb:74:ad initiator50:00:09:74:08:40:05:15 target50:00:09:74:08:40:05:95 target50:00:09:74:08:40:05:2d target50:00:09:74:08:40:05:ad target
You can set the maximum number of LSAN zones, or LSAN count, that can be configured on the edge fabrics. By default, the maximum LSAN count is set to 3,000. You can increase the maximum LSAN count to 5,000 without disabling the switch. The maximum number of LSAN devices supported is 10,000 (this includes both physical and proxy devices). If you have 3,000 LSAN zones but have not exceeded the 10,000 device limit, you can increase the LSAN count to 5,000. All FC routers in the same backbone fabric should have the same maximum LSAN count defined, to prevent the FC routers from running into indefinite state. Asymmetric LSAN configurations due to different maximum LSAN counts could lead to different devices being imported on different FC routers.
LSAN Zone Limit 3000
switch:admin> fcrlsancount 5000
LSAN Zone Limit 5000
Because the maximum number of LSANs is configured for each switch, if there is a different maximum LSAN count on the switches throughout the metaSAN, then the device import and export will not be identical on the FC routers. You should enter the same maximum LSAN count for all the FC routers in the same backbone that support this feature. Verify the configured maximum limit against the LSANs configured using the “fcrResourceShow” command.
Thanks, that was also my thought.
I have been looking into a lot of Brocade documentation, but I can´t find anything to support or clarify that.
Do you or anyone have any Brocade documentation reference to clarify this question?