Brocade Fibre Channel Networking Community

Expand all | Collapse all

Zoneset configuration after setting up ISL

  • 1.  Zoneset configuration after setting up ISL

    Posted 03-01-2015 12:41 AM

    Dear All,

     

      I got a little confused after setting up ISL between 2 brocade san switches. May I know should I use the same zoneset configuration between two san switches? Or I should use different zoneset? Thanks a lot

     

    Best Regards,

    Elroy


    #BrocadeFibreChannelNetworkingCommunity


  • 2.  Re: Zoneset configuration after setting up ISL

    Posted 03-02-2015 04:16 PM
    if the switches are successfully connected with ISL(s), they form a single "fabric". the zoneset activation is fabric-wide.

    you can have more than one zoneset in a fabric, but then one of them will be active (again fabric-wide), and the rest of them will be just stored in the configuration and inactive (again you'll see that these inactive zonesets are identical in all the fabric switches)
    #BrocadeFibreChannelNetworkingCommunity