Brocade Fibre Channel Networking Community

Expand all | Collapse all

how to remove switch from sec policy ?

  • 1.  how to remove switch from sec policy ?

    Posted 05-28-2013 12:14 AM

    Hello Gurus


    I am facing some issue while restoring the configuration of one production (IBM B16-2005)   switch into  backup SAN switch (IBM 2498-B24). When I give the configdownload command, Its gives me following message

    Can only execute this command on the primary FCS switch

    Then from the secpolicyshow command I checked the primary fcs switch(one of our productino

    and I removed this switch entry using following command

    secpolicyremove "SCC_POLICY", \ "

    its remove the list when I check with secpolicyshow command in parent switch but when I check it from the standby switch, its still not allowing me to do restore configuration and showing the above message.

    Please help me either removing this switch from this  centralize management so that I can refresh it with by restoring configuration file or help me reset the configuration of this switch.


    thanks

    regards

    Kamran


    #BrocadeFibreChannelNetworkingCommunity


  • 2.  Re: how to remove switch from sec policy ?

    Posted 05-29-2013 06:46 AM

    Hi Kamran,

    the blocking policy is not the SCC_Policy, the FCC_Policy is blocking you.

    Is the switch online and actual member of the fabric?

    Regards

    Ralf


    #BrocadeFibreChannelNetworkingCommunity


  • 3.  Re: how to remove switch from sec policy ?

    Posted 05-29-2013 11:21 PM

    hi Ralf

    thanks for the reply.

    this switch was configured long time back and it was part of FC network, but its not in use and we want to use it as standby switch where we can restore configuration of B16-2005

    so Ralf: was my command correct to remove this switch from security policy ? if not then how i can remove it or if i can reset it as factory default setting.

    BR

    Kamran


    #BrocadeFibreChannelNetworkingCommunity