Brocade Fibre Channel Networking Community

Expand all | Collapse all

DCX8510-8 Upgrade guide

  • 1.  DCX8510-8 Upgrade guide

    Posted 02-11-2015 12:14 PM

    Hi Folks.

     

    I've just been asked to add 2 DCX48P16GE blades to an 8510-8B switch.  I've looked on the EMC and Brocade support sites, but I don't see an install guide.

     

    I'm trying to find documentaiton to help with the upgrade, such as...  

    1. Is there a prefered slot placement?
    2. Are there any pre-install steps that need to be done before installing the blade  (I can only find replacement instructions)
    3. Will I need to do a firmware upgrade of the blade to match the switch, or will the controlers push the installed version to the blade?

    Any help is appretiated

     

    Thanks

     

    Dan


    #BrocadeFibreChannelNetworkingCommunity


  • 2.  Re: DCX8510-8 Upgrade guide

    Posted 02-11-2015 11:34 PM
    1. No.
    2. No. Just make sure that your current FOS supports this kind of blade.
    3. CP will push the required firmware into the new blade on insertion.
    #BrocadeFibreChannelNetworkingCommunity