Do we need to run "portCfgFillword" on v7.1.1? When I checked about this on the manuals of 7.1, it does not say this command was not supported anymore. After I upgraded to v7.1.1, when I run this command on the port that has connection to 8GB HBA card, it does not support. Brocade SE was telling me that it does not require manuel setup anymore to change this to mode 3. However, there is no way to verifiy what Fillword is running after we connect the HBA. Any idea?
portcfgfillword is still mentioned in the FOS command ref guide for 7.1 h ttp://www.brocade.com/downloads/documents/product_manuals/B_SAN/FOS_CmdRef_v710.pdf but only applies to the 8Gbps plaform.
You can use portcfgshow to the current settings