Brocade Fibre Channel Networking Community

Expand all | Collapse all

Interopmode issue with McDATA switch

  • 1.  Interopmode issue with McDATA switch

    Posted 07-09-2013 04:18 AM

    I have configured Brocade switch with interopmode 2 to migrate McDATA (McDATA Fabric mode)...

    I am getting E-port segmented with zone conflict message on Brocade

    LabSGP:FID128:admin> switchshow

    switchName:     LabSGP

    switchType:     66.1

    switchState:    Online

    switchMode:     McDATA Fabric

    switchRole:     Principal

    DomainIDOffset: 0x60

    switchDomain:   4

    switchId:       fffc24

    switchWwn:      10:00:00:05:1e:0f:6c:9f

    zoning:         OFF

    switchBeacon:   OFF

    FC Router:      OFF

    Allow XISL Use: OFF

    LS Attributes: 

    Index Port Address Media Speed State     Proto

    ==============================================

      0   0   640000 id    N8   No_Light    FC

      1   1   640100 id    N8   No_Light    FC

      2   2   640200 id    N8   No_Light    FC

      3   3   640300 id    N8   No_Light    FC

      4   4   640400 id    N8   No_Light    FC

      5   5   640500   id N8   No_Light    FC

      6   6   640600 id    N8   No_Light    FC

      7   7   640700 id    N8   No_Light    FC

      8   8   640800 id    N8   No_Light    FC

      9   9   640900 id    N8   No_Light    FC

    10  10   640a00   id N8   No_Light    FC

    11  11   640b00   id N8   No_Light    FC

    12  12   640c00   id N8   No_Light    FC

    13  13   640d00   id N8   No_Light    FC

    14  14   640e00   id N8   No_Light    FC

    15  15   640f00   id N1   Online      FC  E-Port segmented,(zone conflict)

    ===

    Prior to change of interopmode I have done cfgdisable, cfgclear, cfgsave at brocade, configured IM 2 with safe zone ON.

    Brocade FOS : v6.4.3d , McDATA is on Firmware Version: 09.08.01

    please suggest...


    #BrocadeFibreChannelNetworkingCommunity


  • 2.  Re: Interopmode issue with McDATA switch

    Posted 07-09-2013 06:58 AM

    "cfgmcdtmode" command, can you verify if McDATA Config mode is enable or disable.

    Additional, i see in switchshow output, the segmented port is set as N1, keep in mind 8G SFP+ not support 1GB FC.

    If you have in McDATA Switch 1Gbits SFP, the you must use is 5100 a 4G SFP


    #BrocadeFibreChannelNetworkingCommunity